Page 4 of 4
Re: Opinions on handloading new brass-
Posted: Sat Dec 11, 2021 8:42 am
by Bill K
Speer ? Or do you mean Berger ?
Re: Opinions on handloading new brass-
Posted: Sat Dec 11, 2021 10:17 am
by K22
Bill K wrote: ↑Sat Dec 11, 2021 8:42 am
Speer ? Or do you mean Berger ?
Oh boy. It's obvious I can't read. I saw a yellow box and read Speer, but I see that his box is Berger.
Re: Opinions on handloading new brass-
Posted: Wed Jan 05, 2022 4:57 pm
by Huskerguy
To take this in a slightly different direction, I purchased some primed Fiocchi for the .204 that had the bullets pulled. The brass looks good, no marks, nice and clean and I checked neck tension with a bullet and it was tight to seat. That's not to say they are all that way. My original plan was to remove my depriming pin and size them just to make sure. And I did measure some at the base and neck and the neck is dead on and even just slightly under specs.