BR PIVOT

Denio · Post by **Denio** » Mon Jun 03, 2013 3:36 pm

I have a Br Pivot with the plastic top and made a wood top out of 3/4 Birch Plywood.. I have the dimensions, but need to know where to drill the hole for the center post assy... I guess I didn't drill the 1st one in the right place...

Mike · Post by **Mike** » Mon Jun 03, 2013 5:32 pm

Denio, please tell me which measurements you need and I'll be happy to take them from my wood top.

Denio · Post by **Denio** » Mon Jun 03, 2013 8:58 pm

Mike, I just need the distance from the front edge of the top to where the 1st holes are drilled, and then from the holes to the right edge...
I drilled mine too close to the front... just doesn't feel right... Thanks...

Denio · Post by **Denio** » Mon Jun 10, 2013 9:13 am

I just need one hole (same one) measured to the front edge and then to the right edge...

Mike · Post by **Mike** » Mon Jun 10, 2013 1:08 pm

Sorry for the delayed response, Denio. I'll take those measurements this evening for you.

Mike · Post by **Mike** » Tue Jun 11, 2013 12:15 pm

Here are some pictures that I hope will help. All are taken with the bottom of the table facing up.

http://flic.kr/p/eJQmMr

From left edge of the table:

From right edge of the table:

From front edge of the table:

Width of mounting plate (left to right):

Length of mounting plate (front to back):

If you need any other shots or have questions about the ones I posted, please let me know.

Mike

Mike · Post by **Mike** » Tue Jun 11, 2013 12:18 pm

Here are some pictures that I hope will help. All are taken with the bottom of the table facing up.

From left edge of the table:

http://www.flickr.com/photos/92543431@N02/9017342137/

From right edge of the table:

http://www.flickr.com/photos/92543431@N02/9017348761

From front edge of the table:

http://www.flickr.com/photos/92543431@N02/9018523316

Width of mounting plate (left to right):

http://www.flickr.com/photos/92543431@N02/9017366107

Length of mounting plate (front to back):

http://www.flickr.com/photos/92543431@N02/9017362661

If you need any other shots or have questions about the ones I posted, please let me know.

Mike

Denio · Post by **Denio** » Wed Jun 12, 2013 8:12 am

Thanks Mike... I was off a little... Extra holes drilled into the top will give it a little patina..
$170.00 plus shipping for a new one was a good reason to build my own... Thanks again... Jim

Mike · Post by **Mike** » Wed Jun 12, 2013 11:21 am

My pleasure, Jim.

BR PIVOT

BR PIVOT

Re: BR PIVOT

Re: BR PIVOT

Re: BR PIVOT

Re: BR PIVOT

Re: BR PIVOT

Re: BR PIVOT

Re: BR PIVOT

Re: BR PIVOT