Barrel breeak in pictures

General discussion and information about the .204 Ruger.
Post Reply
User avatar
Tom Kat
Senior Member
Posts: 630
Joined: Mon Sep 07, 2020 8:04 pm
.204 Ruger Guns: CZ 527, Ruger American Predator in Magpul Hunter stock

Barrel breeak in pictures

Post by Tom Kat »

I finally got out last night and fired my first shots with my new gun. I fired a shot, scrubbed the barrel, ran patches down the bore and fired. This was my first group out of a new barrel, it shows promise!
Last edited by Tom Kat on Fri Feb 16, 2024 1:51 pm, edited 1 time in total.
"The difficulty lies not so much in developing new ideas as in escaping from old ones."

John Maynard Keynes
Top
User avatar
Tom Kat
Senior Member
Posts: 630
Joined: Mon Sep 07, 2020 8:04 pm
.204 Ruger Guns: CZ 527, Ruger American Predator in Magpul Hunter stock

Re: Barrel breeak in pictures

Post by Tom Kat »

I was just trying to get it on paper. I will take it all apart, add a shorter cheek piece, adjust the trigger down, put lower rings on it, and most likely paint the stock. These were some 32 gr Vmax with a modest load of Benchmark-
"The difficulty lies not so much in developing new ideas as in escaping from old ones."

John Maynard Keynes
Top
Bill K
Senior Member
Posts: 2622
Joined: Tue Jan 18, 2011 10:00 am
.204 Ruger Guns: also now, a Savage switch bull barrel in 204R. 23 inch SS
Location: Lake Forest, Ca.

Re: Barrel breeak in pictures

Post by Bill K »

Looking good. A work in progress. Will be watching for further information and results. :)
Top
User avatar
Tom Kat
Senior Member
Posts: 630
Joined: Mon Sep 07, 2020 8:04 pm
.204 Ruger Guns: CZ 527, Ruger American Predator in Magpul Hunter stock

Re: Barrel breeak in pictures

Post by Tom Kat »

Its always fun with a new rifle, looking for that perfect combination
"The difficulty lies not so much in developing new ideas as in escaping from old ones."

John Maynard Keynes
Top
Post Reply

Return to “.204 Ruger Forum”