204Ruger

any one tried these in any calibre cheers bazz

I have been shooting some in .17, .20 and .224. They work right along with the v-max and sierra's in accuracy. And they do explode varmints.. They are added to my bullet line up. Bill K

Been shooting the 55gr. In my 243.
They are accurate enough to do the job, they lack the explosiveness of the tipped competition; but that should be expected.

When discussing the Nosler Varmageddons, keep in mind they offer both tipped and HP versions.....the poly tipped bullet is MUCH more explosive on small critters.

As for accuracy, I've found the flat base of these bullets makes them just a mite more accurate in my rifles than the BT version (Ballistic Tip), just a tad. At least that's my findings so far in .20 caliber.

thanks very much guys there half the price of vmaxs and blitzs here so was hoping to use them in the 222 cheers bazz

The 32 gr. Varmageddon is the most accurate bullet I ever shot in my .204.

Broper,

Please share the powder & Primer you use when loading the 204 ruger 32 gr Nosler Varmageddon.
I have some of these Varmageddon's, Just need to work up a load and try them out.

I have a load for the 39gr Sierra BlitzKing that shoots real well, Now I want to find a 32 gr load that will shoot as well.

Thanks,

Any others that care to share their powder & primer of choice for their Varmaggon loads are also welcome to respond.

I shoot the 55 gr. FBHP Varmageddon in my .223 and the 32gr in the .204......both very devistating on the critters.

thanks guys i got a kg of bm 8208 and some varmageddons so will start load developing tomorrow ill let all know how i go cheers bazz

Bazz, 8208 should work, but I found I had better results, etc with CFE 223.. Check the load books on it and you may find, I got my best accuracy near the max listed loads. In both 223 and 204 Ruger. Bill K

Bazza I'm running Adi 2206h with my varmageddons.It is my go to powder for all my 204 loads at the moment!

i was to boomer i tried a lot of different powders but kept coming back too ar2206h that was until today blowing a living gail and still shot .310 of a inch with lower pressure and much higher velocity i was getting 3670 average with 2206 at 27.5 gr and today i got 3876 with 27.4 of 8208 with lower pressure with 39 gr blitz kings so im a happy chappy still working ont the varmageddons in the 222 cheers bazz

Bill K wrote:Bazz, 8208 should work, but I found I had better results, etc with CFE 223.. Check the load books on it and you may find, I got my best accuracy near the max listed loads. In both 223 and 204 Ruger. Bill K

bill we dont get cfe 223 in aus its hard to get any powder of any sorts u guys are buying 40 tons a year , with u guys comming into winter soon it mite pick up cheers bazz

I used Winchester brass that had been fired 3 or 4 times. All I did was neck size, trim to length, champher mouths inside and out, wiped lube off, cleaned primer pockets. Rem.71/2 primers, 32 gr. plastic tipped Varmageddon. I started with 27 gr. BLC(2) and worked up to 30 gr. in .5 gr. increments. I fired 3 shot groups. 29 gr. was my most accurate load. it measured .168. My biggest group was .721 at 29.5 gr. My rifle is a Rem. 700 VLS. I've had the best luck with BLC(2) powder. I told a buddy about it and he tried it in his Savage .204, he got real good results too.
Bob

Anyone looking for power and primers to try with the 32 Varmageddon should try the following: Tula Small rifle magnum primers or Remington 7 1/2 BR primers (found the Tula primers to be as good for less money.), Accurate 2230 powder or Ramshot Xterminator powder (they are one and the same.) I have tested this combo in multiple 20 caliber rifles including 204 Rugers, 20 Tac, 20 Turbo, and a 20 Practical AI and accuracy has been very good in all of them. Most of the factory 204 Ruger rifles i have tested seemed to perform best towards the top of the charge weight recommended in the Lyman #49 manual.