The only problem i had with my cz 527

General discussion and information about the .204 Ruger.
Post Reply
robert w.
Senior Member
Posts: 165
Joined: Sun Mar 05, 2017 6:59 pm
.204 Ruger Guns: ruger american preditor/cz527

The only problem i had with my cz 527

Post by robert w. »

20171107_161922.jpg
20171107_161922.jpg (815.71 KiB) Viewed 546 times
20171107_161555.jpg
20171107_161555.jpg (980.34 KiB) Viewed 546 times
20171107_161535.jpg
20171107_161535.jpg (919.61 KiB) Viewed 546 times
20171107_161530.jpg
20171107_161530.jpg (1 MiB) Viewed 546 times
20171107_161512.jpg
20171107_161512.jpg (1007.93 KiB) Viewed 546 times
didnt notice till i was about to work cases up and seen sharp scratches in the cases,some were deep ,some not so bad.
I took the magazine apart n dam sharp edges so i break the jewlers files n go to work. Got edges smoothed up still lite scratches on first 2 cases but will get better.
When i open all mags i clean n get all oil out n use heavy coats of dupont tefl0n non stick.dirt dont adhire and wont rust but followers glide nice.
Gamikatsu
New Member
Posts: 16
Joined: Tue Sep 12, 2017 5:49 pm
.204 Ruger Guns: CZ-527 Varming Kevlar/HS

Re: The only problem i had with my cz 527

Post by Gamikatsu »

mine does this as well. i took some 4000 grit polishing paper/sand paper and smoothed the inside of the lips. i still scuff brass but not terrible. i'll see if i can clean it up any more
Post Reply