204Ruger

Bill K wrote: ↑Mon Sep 18, 2017 2:36 pm Went out and fired my 3 shot entry, for the month, with the 204R.
Group... .228
Farthest .250
Total .478
Savage Axis with 26 inch varmint contour, factory barrel bought from a site member and put on this action
T36 Weaver
Hornady brass reloaded with CFE 223, near max load under a Hornady z-max bullet.
Sand bags, from and rear over the hood of my jeep at 100 yards. Some wind, but not much, cloudy skies, temp around 65.

In the target photo you see a group on the other one inch red dot, that is the same load, but with Nosler 32 grain Lead free, need to work on that load, not bad for jacks, but sure would not work well on squeeks. Bill K

Bill K wrote: ↑Mon Sep 18, 2017 2:40 pm

Bill K wrote: ↑Mon Sep 18, 2017 2:37 pm 000_0002 (1).JPG

Bill K wrote: ↑Mon Sep 18, 2017 2:36 pm Went out and fired my 3 shot entry, for the month, with the 204R. Three shots.
Group... .228
Farthest .250
Total .478
Savage Axis with 26 inch varmint contour, factory barrel bought from a site member and put on this action
T36 Weaver
Hornady brass reloaded with CFE 223, near max load under a Hornady z-max bullet.
Sand bags, from and rear over the hood of my jeep at 100 yards. Some wind, but not much, cloudy skies, temp around 65.

In the target photo you see a group on the other one inch red dot, that is the same load, but with Nosler 32 grain Lead free, need to work on that load, not bad for jacks, but sure would not work well on squeeks. Bill K

Bill K wrote: ↑Thu Sep 21, 2017 4:42 pm I would say, that you measured outside to outside, re=measure center to center of the bullet holes and you will bring you group size down and have it correct, as to measuring. But all in all, looking good. even if I had to turn sideways to check it out...just joshing. Bill K